Pushing Housekeeping Status into Cloudbeds

VRScheduler has the ability to update the housekeeping status in Cloudbeds when a task is completed.  You will assign the status to a Task Rule in order to tell VRScheduler how to update the status.

NOTE: The Cloudbeds status will only be updated if the next booking has not checked in.  This alleviates the issue where perhaps a clean was not marked complete before the next check-in . In that case, when you did mark it complete, you would not want the status to update because the unit should stay "Dirty".

Escapia status' are as follows:
Clean
Dirty

Here is the most typical example:
-- You will edit each of your cleaning rules, and set the status on completion to "Clean"

Step by Step instructions:

Step 1:
Navigate to Setup --> Task Rules, then click Edit next to the task that you would like to change the Cloudbeds housekeeping status:


Step 2: Scroll down to Cloudbeds Housekeeping Setting section and choose the status you would like to push when this service is completed.